Hot Rod Forum banner

wheel well

  1. Fabricating Wheel Wells

    Body - Exterior
    I am patching the wheel wells on a car ('68 Impala) and I'm stuck on how to fit and trim the parts. I started with paper patterns which got the patches close, but I can't figure out a good way to trim them to the final shape without making them too small. I've tried fitting them in with the...
  2. Fabricating Rear Wheel Wells

    Body - Exterior
    Hello everyone, I am working on a 1970 Buick Lesabre and the rear wheel wells on both sides are horrible. The previous owner riveted more metal on top of it, which that rusted as well. I have basic tools for fabricating sheet metal, which means I don't have an English wheel that would make this...
Top