Hot Rod Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
37 Posts
If the 1/4 is welded on the seam grind the welds down. Then you could put body filler in where the over lap is and smooth it up to the the body line. As far as the rivet looking things you could probably grind those off and fll in the grind marks with some body filler also. But I would make sure that these rivets aren`t holding the 1/4 in place. If this is the case I would put welds in before grinding the rivets. :cool:
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top