Hot Rod Forum banner
Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
249 Posts
Discussion Starter · #1 ·
My 1980 Z28 has a mounting plate bolted to the body above my 10 bolt rear end and the bushing is missing causing the differential to travel up when I launch it or accelerate hard does anyone know of a replacement bushing and or after market rear pinion snubber that I could replace it with to improve the cars ability to hook up better and not interfere with the exhaust.
 

·
Registered
Joined
·
249 Posts
Discussion Starter · #4 ·
pinion snubber

Well here goes again does anyone out there in hotrodland know of a replacement for a GM corporate 8.5 inch 10 bolt rear end pinion snubber or bumper stop stop it is located and mounted on the floor pan above the differential with 2 screws and a rubber bumperI know chrysler makes them for their 8 3/4 diffs withoutit i wheel hop under a hard launch.
 

·
Registered
Joined
·
249 Posts
Discussion Starter · #6 ·
pinion snubber

Thanks brother but I have a different set up ,leaf springs and my rear end is a floater no control arms or torque arm just a pinion snubber with the rubber snubber worn off. Any other links perhaps
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top