Hot Rod Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Some time ago I bought an economy 10si one wire alternator for my project. Since then I've learned the advantages of a 3 wire setup. The alternator does have accessible regulator terminals. They are covered by a rubber plug. Can I go ahead and just wire it as a 3 wire or isn't that possible once it has been configured as a one wire? I'm doing a complete new wiring job on the vehicle.

Roger
 

·
Registered
Joined
·
161 Posts
Why not ask the source of your alternator that question? That's what I did. In my case, what was sold as a one-wire also functions as a three-wire simply by hooking up the appropriate wire to the two terminal now covered by the rubber plug. But, I'm no electrical expert, so I'd check with the supplier before proceeding.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top