Hot Rod Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I'm in the process, over the Holidays, of installing new races and bearing into my 12 bolt 8.875 passenger rear (Camaro 1970).

Can you please tell me what size race installer and/or size(s) to use? I'm a DYIer and am looking to purchase something within my budget as this will be one and done - well maybe 2x...LoL

I did purchased an inexpensive set and returned as it did not fit race - either race. I would have had to use the flat side that's used for seals to install. The race part numbers are RAT 7005 and RAT 8003 along with associated bearings. No word from manufacture (RATECH) either.

I would appreciate any recommendations.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top