Hot Rod Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
45 Posts
Discussion Starter #1
is this carb a remanufactured carb? i bought this carb back in may of 06 ... springfield oh swap meet ... its a vac. sec carb 600 cfm and ive had problems since ive bought it ... the guy i bought it from put the cool looking 4150 float bowls on it.... looked brand new out of box... now its causing my motor fits... so im going to my other 600 carb to see if that changes anything... does advance or autozone still sell kendall motor oil ???
 

·
Registered
Joined
·
5,391 Posts
This 0-1850 carb set up with good center pivot float bowls should work well assuming it was built up with the 'right' parts. I still have one in my basement that I ran for several years on a Ford 351W but the body shaft holes finally wore out and it's only good for spare parts now. I put this carb together after I had a couple of fires on another vehicle from split 'o' rings on the fuel feed tube to the rear bowl. I wont use a Holley any more with this being one of the reasons.

Dave
 
1 - 3 of 3 Posts
Top