Hot Rod Forum banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
I have just chopped my first rod and it is a 1929 Model a two door sedan. I would like to flush fit the doors on this project. I have seen other fords with this done but all are done in different manners. I have looked for information and literature all over the internet and have had no luck. Any information on the process or references to literature would be greatly appreciated.

thanks [email protected]
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.