Hot Rod Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I would appreciate it if anyone could tell me how to remove the drip rail moldings on my 1964 Pontiac without damaging them.

[ November 18, 2002: Message edited by: Mick ]</p>
 

·
Registered
Joined
·
74 Posts
I have had limited success using paint paddles and tapping with a hammer from the bottom side moving very slow to just release the lip. I almost always plan on new ones.
 

·
Registered
Joined
·
9,050 Posts
there used to be a tool for that i had one and kept the top jaw covered with duct tape to keep from scratching. looked like a pair of pliars with a t welded to both jaws about 2 1/2" wide, the top smooth on the underside the bottom had seration grippers, drip rail trim practically falls off . try a trim shop they used to use them before applying or removing vinyl tops.
 
1 - 3 of 3 Posts
Top