Hot Rod Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
I have purchased a 70 chevelle 4 door.I plan on doing some basic mods including a H/C/I,shift kit and a Saturday night special converter in the power glide.I am trying to decide on either 3.42 or 3.73 gears.The cam I am going to use is the Crane 274 ho6.I plan on using a Holley 570 street avenger carb and a Weiand street warrior intake.Heads are going to be a set of 416 heads.Of course I will have headers and a 2.25 dual exhaust with an x pipe and flows.I feel this will be plenty for the 77,000 mile 307.I am not building a race car,just a cruiser.:thumbup:
 

·
Registered
Joined
·
12,338 Posts
I think putting a turbo 350 with stock converter(or small stall if budget allows) would be a better investment over a stall in a glide and gears. Nothing wrong with a 307. Dont be shy on the exhaust,2 1/2 is better.The only thing I didnt like about the 307 is they had a nylon gear on the camshaft.New timing set with the new cam will fix that. Other than that,just treat that engine likes its an under sized 327.
 

·
Registered
Joined
·
23 Posts
Discussion Starter · #3 ·
Yea,I know a th350 is better ,but I just wanna see what I can do with what I got rather than changing a whole lot.I need hardened seats for unleaded fuel hence the 416 heads.The cam is just for the lope and I figure the other parts will compliment it.
 

·
Registered
Joined
·
12,338 Posts
the 3 speed by itself will improve the car the most.A bigger cam in a glide car with near stock gears and it wont make much difference. Did the stock heads fail you already because of unleaded fuel?
 

·
Registered
Joined
·
12,338 Posts
first gear turbo 350 2.52x3.07=7.7:1 launch gear

power glide 1st gear- 1.72x3.73=6.4 launch gear

spending money on gears and high stall will just cut your fuel economy. might even slow the car down?
 

·
Registered
Joined
·
23 Posts
Discussion Starter · #7 ·
I'm gonna crawl under the car and check te numbers to see wat ratio is in the diff.This car as working R134 converted a/c and I was told that pg cars with air have 3.36 gears.
 

·
Registered
Joined
·
12,338 Posts
not all diffs are tagged with the ratio.Tou might have to do a gear oil change to find out.3.36 is not a terrible ratio couple with a 3 speed,and even better with a 4 speed auto as they have a 3:1 first gear ratio.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top