Hot Rod Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
i want to lower my old bump and was wondering if i could get about a 2 inch drop in the front by cutting the coils and still be able to get the beams aligned

i'm also trying to do this for free.99, i have the time just not the money

and i want about 2 inches out of the back to so if you got a good cheap method im game
 

·
Of course it's fast
Joined
·
2,670 Posts
Rear: axle flip (best method to go real low since you can add blocks for more lowering), shackles, lower stiffer leaf springs.
Front: spindles, springs (cut or buy new ones).
 

·
Registered
Joined
·
7,528 Posts
Can't cut springs on that being there are no balljoints/ possibility of balljoint adjusters like the later trucks. No drop spindles available for the Twin I beams. Only solution is the Panther car front ( bolt on swap ) or Dream beams/ Belltech beams.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top