Hot Rod Forum banner
1 - 2 of 2 Posts

·
OFMF
Joined
·
42 Posts
Discussion Starter · #1 ·
Greetings all,

I have a 70 Monte that i am restoring and I want to take the engine compartment wiring harness off the firewall. There is a 3/8" bolt in the center of the main connector ( I believe that this connects to the fuse panel) on the firewall to the left of the steering column. Before I pull the bolt and start pulling/prying the connector, I was hoping to get some tips on just how to do this without messing up the connector. I would be greatly appreciated if someone could post a pic or 2 of the connector and how it comes apart. Thanks in advance for your help.

Pat
 

·
OFMF
Joined
·
42 Posts
Discussion Starter · #3 ·
Thanks 302,

Just like you said - right down to the corrosion in the lower left corner. It was stuck a little but it came off fairly easy. Thanks again for the help. Now for the dirty work. Here's a few pics of my progress so far.







Also found the reason why I could not get much air flow through the AC


 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top