Hot Rod Forum banner

1996 Blazer 4x4

874 views 2 replies 3 participants last post by  opus70 
S-10 ??

The easiest and cheapest way is to get the front cv axles and gut them and reinstall just the ends through the wheel bearings.u can cut the cups off the inside as u see fit. then its 2wd and the wheel bearings wont come apart.

The cv axles hold the bearing and spindle press fit in place,without the axle syub and nut torqued in place the spindle will walk out and it will be ugly.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top