Hot Rod Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
161 Posts
Discussion Starter · #1 ·
I'm deleting the oil cooler/heater from a 96 LT1. I have part GMPP 3952301 that the filter will screw on to. Question: does orientation front to back matter when bolting on the mentioned part? I see there is a hole machined into the block on one side and I don't know if that matters in terms of the direction the part is facing.

Also, the machined area on the block is 4" at the widest, while the filter gaskets I've checked are only 3.66" in diameter. The machined area on the block is wide enough to accommodate the smaller diameter filter gasket. I suspect this is not an issue, but would like confirmation from someone more knowledgable that me.

Thanks for the help.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top