Hot Rod Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I'm just finishing up building my '65 283 and plugged the rear(draft tube/vent) on the back of the block with a frost plug in favor of traditional PCV set-up(breather on left VC and PCV on right. I've looked through all the previous posts on this topic and could'nt locate a part number for the recommended PCV valve I should use. I know many will fit the grommet on the VC but I would like to put the proper valve in. Any Suggestions?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top