Hot Rod Forum banner
1 - 1 of 1 Posts

·
Member# 3287
Joined
·
2,625 Posts
Q#1: I agree with the valve adjustment procedures, as noted above, but I only go 1/2 turn after zero lash. Some even say 1/4 turn. After break-in, I go back and recheck them running and warm.

Q#2: Did you rehone the cylinders before you installed the new rings? They need a fresh surface. Have the rings even seated yet? It sounds like the engine is still fresh.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top