Hot Rod Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
Hi Got the crank specs for a 350 chevrolet, can anyone tell me if the rods and mains are stock?

Mains are: 2.448, 2.447, 2.447, 2.447, 2.447

Rods are: 2.098 across the board.
The end is 3.738(where the rear 1piece seal goes)

thanks in advance,
Jose :welcome:
 

·
Registered
Joined
·
286 Posts
airjose said:
Hi Got the crank specs for a 350 chevrolet, can anyone tell me if the rods and mains are stock?

Mains are: 2.448, 2.447, 2.447, 2.447, 2.447

Rods are: 2.098 across the board.
The end is 3.738(where the rear 1piece seal goes)

thanks in advance,
Jose :welcome:
While the crank has not been ground, your specs reveal that the crank is well worn.

sam-missle
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top