Hot Rod Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
442 Posts
Discussion Starter · #1 ·
I want to recover my running boards with black ribbed rubber. I found replacement rubber on the Steele website, but they are very pricey. Does any one have a suggestion where I can get linear ribbed rubber stock that I could cut to fit? I am not concerned about the smooth feature of the originals around the fender lines. I suppose I will direct glue them to the running boards. was thinking of using an exterior grade contact cement for that job. The exposed outside edge will be trimmed with a s.s. edge band.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top