Hot Rod Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
37 Posts
Discussion Starter · #1 ·
Engine mounts are located at front of motor secured by two long bolts on each side that either stretch or break under hard acceleration. Any ideas on maybe using aircraft grade bolts that won't stretch or maybe something else ?
 

·
Registered
Joined
·
4,329 Posts
Lets see a picture(s) of these engime mounts.
Take a picture with your phone then use the picture link at the far right on the upper row of icons below the text box.
 

·
Registered
Joined
·
2,291 Posts
Second thread , same topic , something is wrong ( obviously) need pictures ! Its like your wife calling from the store to ask if the pants she's trying on make her butt look big !
 

·
Registered
Joined
·
62 Posts
i was like, wait i have seen this exact thing before, was it facebook, twitter, Instagram, the hamb, dang i cant remember..
pretty sure the comments went something like, impossible, use grade 8 bolts, post pictures, probably something else going wrong like trans is moving causing the combo to twist, etc
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top