Hot Rod Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
Alright guys, all the pieces and parts have arrived and I am ready to start the mock up assembly of my 383 to make the required clearances. I need some advice on the details..

Can somebody please break down the steps of the mock up assembly in detail? I have the basics down, just want to make sure I have all the details down pat too.
 

·
Registered
Joined
·
18 Posts
Discussion Starter · #3 ·
so obviously the cam needs to be installed during the mock up to check cam to rod clearance, but can the cam be installed without assembly lube? The lube would throw off my measurements, right? Also, do the bearings need to be lubed up or will they be fine dry since you are only turning the motor over by hand?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top