Hot Rod Forum banner
1 - 6 of 6 Posts

·
Junkyard Kustoms
Joined
·
298 Posts
Discussion Starter · #1 ·
What kind of cars/ truck engines would have a header that would fit on this engine.. or the dimensions of the exaust manifold face that contacts the block... im thinking of building custom headers.....
 

·
Hotrodders.com moderator
Joined
·
9,581 Posts
Template

You can use the exhaust manifold gasket as a template to cut an exhaust flange for that motor..

Then get some of the bends in a box and weld up your tubes to fit your chassis..

Good luck

OMT
 

·
Hotrodders.com moderator
Joined
·
9,581 Posts
Owwww

H,mmmm well I am not up on everything out there..lots of changes have been implemented..

maybe take the dimension's off of the existing manifold and do some checking with some of the race suppliers as to a gasket material..

Where there is a "I want to" there is a way..

OMT
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top