Hot Rod Forum banner
1 - 1 of 3 Posts

· Registered
40 Posts
Discussion Starter · #1 ·
I am almost finished with chopping both doors. I needed to take a break from the rear of the cab. All that welding, hole making, and grinding sucks. When I welded the doors in place I noticed that the gap was not even all around (even though the door was centered. I was thinking about welding a 1/2 inch wide strip of steel and creating a 1/4 inch gap between the door and body then welding/filling the gap on the other side . Any suggestions?

1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.