41 WILLYS - MAKE FLIP FRONT END ON STREET BEAST

2299 Views 3 Replies 4 Participants Last post by Barz51, Dec 23, 2002

bobthetran

Discussion Starter · Dec 21, 2002

I WOULD LIKE SOME SUGGESTIONS ON WHERE TO CUT THE FRONT FENDERS & ON WHAT ANGLE.HINGEING THE FRONT END TO THE FRAME & THE TYPE OF FASTENERS WOULD BE HELPFUL.I WOULD LIKE TO BE ABLE TO REMOVE IT FROM THE CAR AS AN OPTION.I'M SURE THERE ARE THINGS TO BE CAREFUL OF.ALSO MERRY CHRISTMAS & HAPPY NEW YEAR TO ALL YOU FINE PEOPLE.BOB

Save

1 - 4 of 4 Posts

Will's41

· #2 · Dec 21, 2002

Hey Bob, have you checked out the street beast site? There is a guy doing just that in the "under construction" area. Maybe you can get in touch with him.
http://www.streetbeasts.com/nuindex.html

Save

[email protected]

· #3 · Dec 23, 2002

The one I did for my friend's truck doesn't have cut fenders. The hood slides forward then tilts up to clear the door hinges. We hid roller bearing slides inside the stock front frame rails and put one ball bearing slode on the center back of the hood that drops into a guide on the stock firewall.

Save

Barz51

· #4 · Dec 23, 2002

Happy new year to you too Bob. Pleas tell me "bobthetran" is not short for bob the transvestite

Cory

Save

1 - 4 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month