Hot Rod Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I have a 66 Cyclone. When I measure from the ground the left and right wheel wells one side is 1/2 higher then the other. The tiers are the same size, the floor is level, all the supension parts are the same. When I place a level across the fender and over the shock towers it is level. I measured from inside fender to the uper control arm and one control arm is 1/2 inch higher. how do I fix this so all parts of my car is level. Ed
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top