Hot Rod Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
87 Posts
Did you verify the output shaft you installed was a 700R4? The 4L60E is the same except it doesn’t have the grooves cut into the shaft to drive the governor. Just a thought.
 

·
Registered
Joined
·
87 Posts
The check ball in the middle of the picture goes up and sits in the tear drop hole directly above it.
There is nothing wrong with the holes in the bath tub on the top right. The check ball will seal one or the other.
 
1 - 2 of 2 Posts
Top