Hot Rod Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
141 Posts
Discussion Starter #1
I mounted my A/C unit in and cut the bulk heads in the body, now I would like to use hard lines (alum) from the bulk heads to the A/C unit. I would also like to make some hard lines for the compression, what is a good hand tube bender, anyone have a recommendation, also want to make some heater hard lines which is 5/8 tube, so I will need a bender for 5/16, 1/2 and 5/8 tube.

Regards,

Steve
 

·
Registered
Joined
·
183 Posts
I bought my lines from Vintage Air, and my bender from Godman($$). In retrospect, I think an inexpensive bender from Home Depot would have done as well on the aluminum lines. Bill :)
 
1 - 2 of 2 Posts
Top