Hot Rod Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
744 Posts
Discussion Starter · #1 ·
Hey everyone,

Just curious if anyone has any info on this flatbed. I have never seen one like it before. Its very well made with all the welds ground down and all stainless hardware. The welds on the diamond plate tubs are nearly perfect also. Its on my 58 Chevy.

Thanks
 

Attachments

·
Registered
Joined
·
744 Posts
Discussion Starter · #6 ·
Since the picture was taken I have re-finished the bed and truck. It was made from 1-1/4 or 1-1/2 plywood. There are no unused holes or re-welds anywhere on the frame or bed so I don't think it was ever used for a 5th wheel but the low height sure makes it easy to load up. The bed matches up to the frame perfectly so I'm pretty sure it was made for the truck. Or at least that era of trucks.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top