Hot Rod Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
225 Posts
Discussion Starter #1
I had originally asked this on the transmission board because it's related to a 700 r4 upgrade but it's a question for the carb experts.

I have a quadrajet off a 79 truck and I'm installing a 700 r4 tranny. The bellcrank doesn't have a place to hook up the trannys detent cable, at least not one with the proper geometry and stud. I can probably get another parts carb with the proper bellcrank. Is it possible to remove and swap the bellcranks and rod it's attached to that goes through the carb? If so how tricky is it. I don't want to attempt this if springs and things are going to fly all over the place.
 
1 - 1 of 1 Posts
Top