Hot Rod Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hello,
I have searched your data base and I cant find an answer to a question I have. I have a 17ft alluminum boat that the previous owner used bondo on to repair loose rivets. he glopped it on real thick, does anyone have any ideas how to remove this without doing damage? I sure would appreciate the help. thx
 

·
Administrator
Joined
·
18,484 Posts
A little bit of heat from a propane torch will probably loosen it up a bit. Don't overdo the heat.

Don't know why you are asking this in a Hot rodding forum.....welcome anyways. Why not tell us about your Hot Rods?
 
1 - 2 of 2 Posts
Top