Hot Rod Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter · #1 ·
Is it possible to bypass a distributor module? I was told that I colud but wasn't sure how to do it or what gauge wire I would need if I even need wire to bypass it. The car is just a pit beater/ice racer so it does not need to pass a highly detailed tech or safety inspection.
 

·
Registered
Joined
·
27 Posts
Discussion Starter · #4 ·
crappy car, replaced the module and it works, car started before with timing out 37 degrees but won't start now, figured that if the module blew up again i could just bypass it like some suggested i do in the first place. If u guys can't give any sugestions, no problem don't worry about it.

BURN BABY BURN!!!!!!!!!!!!!
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top