Hot Rod Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
289 Posts
Discussion Starter · #1 ·
Hey guys. I have a small block chevy that Im building and have been pulling my hair out trying to decide on a cam so I though Id seek some opinions. Below is a list of things done to the motor. It is a street car that I will take to the track on the weekends. Any help would be much apreciated.

Fresh SBC bored .030 over
Stock cast flat top piston/cast crank/stock rods (10.5:1??)
Edelbrock Performer RPM Air Gap intake
Edelbrock Performer RPM Cylinder heads (64cc)
Holley 670 street avenger carb
Headers
Magnaflows
MSD 6AL box/MSD distributor
 

·
Registered
Joined
·
289 Posts
Discussion Starter · #7 ·
Change of plans.......Untill I flip flop again :>) AFR has a dyno tested combo on there site. The bonus is they use a Comp Magum 270H cam and I have a brand new one that I wasnt going to use. Figure use the money I was going to spend on a cam and spend it on better heads...What do you guys think?? Combo makes 430HP @ 5500 and 470 ft lbs @ 4500

How accurate do you guys think those specs are??
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top