Hot Rod Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
First off, I have a 1959 Chevy 283 that was rebuilt stock last year. It was a 2 barrel engine. After the rebuild i put a weiand street warrior intake with a edelbrock 600 4 barrel, 262 Comp extreme energy cam. The problem is that it runs fine, starting, idling, but when you put in gear it drains the motor down. And its weak. Do i need a stall? Or timing issues, carb adjustments? Or is it the stock heads? ANY HELP?::confused:
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #7 ·
Im not sure on most of these questions. I have very little knowledge on engines. Someone rebuilt as stock with a 2 barrel. While still fresh, i had someone install cam and intake. Its just flat running. And as before it loses alot of power when put in gear. Torque converter issue? And the heads are stock. Im not sure which way to turn. Could be simple or expensive....
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top