Hot Rod Forum banner
1 - 4 of 4 Posts

·
the 'Duracell Project'
Joined
·
2,564 Posts
pretty amazing for the 70s technology. 16 exhaust ports. counterclockwise rotation for cams. check out the idler pully machined into the water pump. i'd hate to change that timing belt
 

·
Registered
70 Camaro, 66 Buick special, 2019 Camaro ZL1/1LE
Joined
·
2 Posts
If I remember that article right they used a set of Nissan cylinder heads for the design. Been a long time since I’ve seen that but a buddy of mine and I were just talking about it,
 

·
More for Less Racer
Joined
·
20,574 Posts
How about a Dominion 4-valve, hemi-style, shaft rocker cylinder head for SBC's.
Arao Engineering was the company, too bad it never went anywhere, it looked interesting back in the day.
They were also planning to do BBC and SBFord but I don't know if any were ever done.

Motor vehicle Style Engineering Automotive design Mechanic


Motor vehicle Style Combat vehicle Engineering Machine



I remember some of the Aardema and Moser stuff from the 1980's also. Interesting that Aardema ended up connected to the Moser stuff.
 
1 - 4 of 4 Posts
Top