Hot Rod Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
289 Posts
Discussion Starter · #1 ·
Is it okay to use a Brass crimped wire wheel on a die grinder to clean old gasket material and carbon from the mating surface of aluminum heads.I tried a small area and it looked pretty good. I would also like to clean the carbon from the valves using this method

Please advise
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top