Hot Rod Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
258 Posts
Discussion Starter · #1 ·
I purchased a used sata nr2000 a few months back for my project but, after reading some threads about how this gun is an air hog I checked the specs on my compressor. It is a 7 hp 60 gallon tank unit that produces 11.8 cfm at 40 psi but, apparently this isn't enough. So, will this work for me or should I look for another gun? I just bought the compressor last year so I don't want to replace it. Thanks.
 

·
Registered
Joined
·
3,591 Posts
Had a neighbor a few years ago with almost the same set up but in a portable sears compressor.
The NR worked good for him but when shooting clear could only do a side of car and then had to wait for compressor, however I think his was 30 gallon tank. Base was fine.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top