Hot Rod Forum banner
1 - 1 of 1 Posts

· Registered
342 Posts

If you want some info on clip installation, check out <a href="" target="_blank">this site</a>. There's a few ways to go with the AD trucks to get IFS. The balance between cash spent, ease of project and final result isn't always equal. I've heard of AMC Pacer crossmembers being bolted in, early '80's Chevy 1/2 ton crossmembers bolt in, 2nd gen F-body clips weld in, aftermarket MII welded and bolted in. I swapped an S-10 chassis under my '52 Suburban (same chassis as your '51 pickup) - not worth the trouble, unless you are set on having 4WD and IFS.

The good news is that there's lots of sites out there for you to research. :) Good luck!
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.