Hot Rod Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
5,784 Posts
don't OOPS ! !

On the one I had you had to have the distributoro loose in the manifold hole and put the distributor and intake manifold down the same time. I had a mallory dual point distributor that used the crab Dist cap. 4 wires going east and 4 going west.
 

·
The Smell of Nitro in the morn
Joined
·
2,411 Posts
Edelbrock is junk, I replaced mine with a Weiand , plus its a air gap from the 60's which 40 years later is new to Edelbrock intakes

Weiand is the best cross ram I have used to date, tuning is no problem if you know what your doing.
Idles at 650 rpm with 2 X 650's & annular boosters, use square jetting
A Roller motor is the best way to go.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top