Hot Rod Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
Hi

I'm a new member of Hotrodders and was hoping someone could advise me on companies that make custom drive shafts. I'm building a 32 Ford 3 window coupe with a SBC and th350 tranny. I need to get a drive shaft made up.

I came across a company called Rescission Shaft Technologies while searching the web. Does anyone have any experience with this company?

Thanks
Legacy
 

·
Registered
Joined
·
245 Posts
custom driveshaft

I dont know where in md. you are located,but if you are near any fair sized city there should be a driveshaft shop that can build you a new shaft.I would advise getting it done locally if possible,in case of problems. I work in a shop in nw.pa that builds driveshafts,we just built one last week for a 29 roadster with a 327 and a turbo 350 trans. I think a complete new shaft(yokes,tube and ujoints) was about $160-$175. :cool:
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top