Hot Rod Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
137 Posts
Discussion Starter · #1 ·
i'm building a 1936 ford 3 window coupe with sbc on an original frame. i'm in vermont so it's not like were near a big city and can get anything you want made.

my problem is i have a set of hedders and i need a custom exhaust. yes any muffler shop can bent up regular steel pipe, what i want is all stainless steel 2 1/4" pipe. one guy close to here said he could do it but man he wants $20 per foot hummm lets see there are two sides on a sbc at about, well you know smeems quite high.

have any of you folks done this or have an idea if this cost is right?


thanks bomo
 

·
Registered
Joined
·
4 Posts
Hi Bomo
Just had a custom exhaust done on a 37 sedan, all the way from the headers to the tips 2 1/2 inch pipe all the way back custom bent with their mufflers or yours, price was good. where in vermont are you this place is in saratoga springs NY.
 

·
Registered
Joined
·
4 Posts
Hey Bomo,
I didn't realize I pushed the wrong buttom, I went back and set it up to get e-mail. I sent you a note. I have my receipt right here and the total job was $ 350.00 aluminum coated pipe 2 1/2 inch all the way back welded. and they do a nice neat job.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top