Hot Rod Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
136 Posts
Discussion Starter · #1 ·
I sent my gx120 Honda pushrods to smith brothers to have a new set made but got turned down. Does anybody know of a company that will make em for a small engine?
 

·
WFO
Joined
·
5,030 Posts
I sent my gx120 Honda pushrods to smith brothers to have a new set made but got turned down. Does anybody know of a company that will make em for a small engine?
If you can use 5/16" OD p-rods, you can get them custom from several makers. Manton (page 7) should be able to fix you up, they have them down to 3/16".

I was curious so I looked around some. Seems they're available 0.100" shorter like for different rockers or heavily milled head from NR RACING.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top