[eutu1960]

Anyone now where I can get a converter cut and cleaned near 17921 Ashland, PA.
My planetary gears in my 700R4 went and I need to get all the junk out or buy a new converter.
Thanks In Advance for any info.

 

[ericnova72]

If it is a hi performance converter, you send it back to the builder.

If it is just a stock converter, the cost of the cut/clean/inspect/repair/re-weld job is close to just the cost of a new remanufactured converter

 

[eutu1960]

If it is a hi performance converter, you send it back to the builder.

If it is just a stock converter, the cost of the cut/clean/inspect/repair/re-weld job is close to just the cost of a new remanufactured converter

I have a after market converter, cost of shipping would make it expensive, that is why I am looking for someone local.

 

[ExcellenceAuto]

$30 each way?
Where do you live? That could change things...

 

[eutu1960]

$30 each way?
Where do you live? That could change things...

I Live 17921 area Ashland, PA, I can ship it back to Edge Racing Converters, More Horsepower with More Torque Guaranteed! in CA. it will cost me $150.00 plus shipping

 

[3w coupe]

Transmission Specialties in Aston PA is probably the closest to you or ATI in Maryland

 

[eutu1960]

Transmission Specialties in Aston PA is probably the closest to you or ATI in Maryland

Thanks for the info over two hour drive so I might just get a new converter.

 

[eutu1960]

I was at the local NAPA this morning and asked if anyone there about having my toque converter cut and they suggested a place about an hour from me called Home - C2 Competition so I sent them an email and hope to here from them next week.

 

[eutu1960]

I never did here back from C2 Competition, so I ordered a new torque converter
from Home - ProTorque | High Performance Drag Racing Torque Converters hopefully it will be here tomorrow. 2400 stall

 

[eutu1960]

My new torque converter came in asap The Torque Converter Is In

 

[eutu1960]

Well the trans is back in and the vette is up and running.