Hot Rod Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
78 Posts
Discussion Starter #1
Im going to cut the wheel wells round on a 1957 Ford custom and I like the lep Iv' seen on some of them how do you do this body work is not my cup of tee I would just like to do this right! the first time.. <img src="graemlins/mwink.gif" border="0" alt="[mwink]" />
 

·
Registered
Joined
·
313 Posts
A lot of guys will rig up an a device that draw a radius from the axle. If you want the unflared gasser wheelwell look, just weld a piece of 3/8 round stock inside the wheelwell for support.
 

·
Registered
Joined
·
78 Posts
Discussion Starter #3
I know what you mene I did that with a 55 chevy. but I was thinking of a small lep on the out side of the wheel well. <img src="graemlins/mwink.gif" border="0" alt="[mwink]" /> Ps I do love the gasser look!! <img src="graemlins/mwink.gif" border="0" alt="[mwink]" /> <img src="graemlins/mwink.gif" border="0" alt="[mwink]" />
 
1 - 3 of 3 Posts
Top