Hot Rod Forum banner
1 - 2 of 2 Posts

1 Posts
Discussion Starter · #1 ·

I am finishing up the install of a ZZ4 crate motor in my 73 Stingray. I purchased a CVR high torque starter to go with. Of course the new CVR starter did not come with any wiring info what so ever, and it only has two wiring posts vice three (like my original starter.)
Another issue (on the new CVR starter) is the main post and the knife post are very close together, so close in fact I am concerned the wires may touch -- I can't imagine anything good coming from that.
Anyone ever done one of these or have any recommendations?


1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.