Hot Rod Forum banner
1 - 2 of 2 Posts

·
Listen and Learn
Joined
·
1,809 Posts
Discussion Starter · #1 ·
I have been modifying a couple heads here and there for screw in studs and larger springs and higher valve lifts. I was wondering if you guys have any good ideas on building a fixture that will allow me to do this on the drill press. I have been doing them with a variable speed corded drill and im just looking at a more efficient way to do these and also I can do it with a consistent speed and pressure if i do it with a drill press. Im looking at something that I can bolt to the table and fasten a head to it. 99.9% of what I do is SBC so I will build it for that.

Any ideas on what is available out there on the market for me to maybe purchase directly? I can make it but If I can find something like this already built for a reasonable price it will probably be worth it.

Thanks!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top