Hot Rod Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3,265 Posts
Don't know how its in, but theres only two ways. If its a rubber seal just use a metal spatula or drywall puddy spredder and lift the rubber seal and run it under the glass and around. If its the gummy urethane sealent stuff just get a thin peice of wire (piano, guitar string etc) anything will work, run it through the seal, wrap both ends around a dowel or stick to hold on to it and pull around the windsheild to cut the seal then it should lift right out without any problems.

HK
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top