Hot Rod Forum banner
1 - 2 of 7 Posts

· Registered
37 Posts
Discussion Starter · #1 ·
Has anyone put a '32 shell on a 30/31 Model A. Mine seems to be too tall causing the hood gap at the rear to be off (wide at bottom). Also the hold down clamps barely reach. I'm thinking I need to trim about 3/8to 1/2 inch off the sides. I have two thin shims under all the body mounts & the doors are aligned fine. Thanks, Dale
1 - 2 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.