Hot Rod Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
126 Posts
Discussion Starter · #1 ·
I was just curious as to what the main differences between a performer intake and a performer rpm intake are for sbc. When looking at the two next to each other they are very similar except the rpm is slightly taller. Are the runners the same size? Lets just say you were to put a 1 inch divided spacer on top of the performer, would that basically make it equivalent to the rpm?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top