Hot Rod Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter · #1 ·
im looking for someones advise on my s10 project, im putting in a 350 and was wondering if i should stick with the 2 piece drive shaft or have a one piece made?
any one who has done this project i would like to know!
thanks.
 

·
Administrator
Joined
·
10,120 Posts
beach_boy327 said:
im looking for someones advise on my s10 project, im putting in a 350 and was wondering if i should stick with the 2 piece drive shaft or have a one piece made?
any one who has done this project i would like to know!
thanks.
read this thread

perhaps it will help
 

·
Banned
Joined
·
1,971 Posts
tape measure and junkyard

you can find a one piece to work

if you search enough

check all older gm cars and shorter trucks, evne shortbed full size C/K ones and K series blazers too



goo dluck
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top