Hot Rod Forum banner
1 - 10 of 10 Posts

·
Registered
Joined
·
257 Posts
Discussion Starter · #1 ·
I am wondering if anyone can tell me the limitations a 10 GM posi with 4.10 gears has. I've just completed a 546 HP 486 lbs of torque 383 stroker and question if the rear end I have is going to be able to handle it. Any thoughts?
 

·
Registered
Joined
·
400 Posts
And whats it going under...car,truck,cement mixer? whats it's intentions, street,strip?.transbrake?. Is it going to see slicks?What axle's?. Is there a c-clip eliminater kit in it?
 

·
Registered
Joined
·
257 Posts
Discussion Starter · #6 ·
10 bolt

Thats kinda what I was thinking. I've got an opportunity to buy a narrowed 12 bolt with 33 spline Strange axles ...ladder bars...billet yoke... aluminum cover...4.88 Richmond gears... all new for 1250.00. Good deal?
 

·
High Performance Rear Ends
Joined
·
3,782 Posts
Is it the right width for your truck? Do you want 4.88 gears? If it has a spool then it't not going to be worth a crap on the street. Ladder bars are noisy and stiff on the street. If it's what you want then the price isn't too bad. What are you going to do with the truck?
 

·
Registered
Joined
·
12,338 Posts
Us e traction bars for a street car. A lot of people dont know how to drive with ladder bars,they are not very forgiving if you chop the throttle at high speed,especially on slicks
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top