Hot Rod Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
9,050 Posts
I am doing one for a customer.. 54 Chrysler New Yorker. Not cheap!!

This engine had extensive rust in cylinders. Had to be bored at least .060. Could not find any sources stocking decent compression pistons, so I bored it to 3.875" to get readily available rings and ordered custom pistons for that bore size.

Also had problems locating decent undersize bearings. Hot Heads Research & Racing Early Chrysler Hemi Home has been some help.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top