Hot Rod Forum banner
1 - 2 of 2 Posts

· Registered
10 Posts
Discussion Starter · #1 ·
383 stroker, 700R4 beast, RPM Edelbrock Air-gap manifold, Quickfuel SS-780VS carb (AKA Holley 4150), and Jegs adjustable hard line dual feed
. I think I have the low profile brake booster manifold connection solved with
this item. Problem I still have is the heater hose to manifold connection being too close to my carb hard line. I heard that there is 45 degree 6-AN fitting that connects from the carb feeds to the hard lines and raises the hard lines enough to get the heater hose under. Prob is I cant seem to find one. Anyone know where I can find this fitting or how to fab one. Checked forum to no avail. :confused:
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.